Sequence stratigraphy

Sequence Stratigraphy is a branch of geology that attempts to subdivide and link sedimentary deposits into unconformity bound units on a variety of scales and explain these stratigraphic units in terms of variations in sediment supply and variations in the rate of change in accommodation space (often associated with changes in relative sea level). The essence of the method is mapping of strata based on identification of surfaces which are assumed to represent time lines (e.g. subaerial unconformities, maximum flooding surfaces), and therefore placing stratigraphy in chronostratigraphic framework. Sequence stratigraphy is a useful alternative to a lithostratigraphic approach, which emphasizes similarity of the lithology of rock units rather than time significance.

Sequence stratigraphy deals with genetically related sedimentary strata bounded by unconformities.

The 'sequence' part of the name refers to cyclic sedimentary deposits. Stratigraphy is the geologic knowledge about the processes by which sedimentary deposits form and how those deposits change through time and space on the Earth's surface.

Significant surfaces

Sequence boundaries

Sequence boundaries are deemed the most significant surfaces. Sequence boundaries are defined as unconformities or their correlative conformities. Sequence boundaries are formed due to the sea level fall. For example, multi-story fluvial sandstone packages often infill incised valleys formed by the sea level drop associated with sequence boundaries. The incised valleys of sequence boundaries correlate laterally with interfluves, palaeosols formed on the margins of incised valleys. The valley infills are not genetically related to underlying depositional systems as previous interpretations thought. There are four criteria distinguishing incised valley fills from other types of multi-story sandstone deposits: a widespread correlation with a regional, high relief erosional surface that is more widespread than the erosional bases of individual channels within the valley; facies associations reflect a basinward shift in facies when compared with underlying units; erosional base of the valley removes preceding systems tracts and marine bands producing a time gap, the removed units will be preserved beneath the interfluves; increasing channel fill and fine grained units upwards or changes in the character of the fluvial systems reflecting increasing accommodation space. Sandstone bodies associated with incised valleys can be good hydrocarbon reservoirs. There have been problems in the correlation and distribution of these bodies. Sequence stratigraphic principles and identification of significant surfaces have resolved some issues.

Parasequence boundaries

Lesser importance is attached to parasequence boundaries, however, there is a suggestion that flooding surfaces representing parasequence boundaries may be more laterally extensive leaving more evidence than sequence boundaries because the coastal plain has a lower gradient than the inner continental shelf. Parasequence boundaries may be distinguished by differences in physical and chemical properties across the surface such as; formation water salinity, hydrocarbon properties, porosity, compressional velocities and mineralogy. Parasequence boundaries may not form a barrier to hydrocarbon accumulation but may inhibit vertical reservoir communication. After production begins the parasequences act as separate drainage units with the flooding surfaces, which are overlain by shales or carbonate-cemented horizons, forming a barrier to vertical reservoir communications. Sequence stratigraphic principles have optimized production potential once reservoir scale architecture is identified and separate drainage units identified.

Systems tracts

The concept of systems tract evolved to link the contemporaneous depositional systems. Systems tract forms subdivision in a sequence. Different kind of systems tracts are assigned on the basis of stratal stacking pattern, position in a sequence and in the sea level curve and types of bounding surfaces.

• A lowstand systems tract forms when the rate of sedimentation outpaces the rate of sea level rise during the early stage of the sea level curve. It is bounded by a subaerial unconformity or its correlative conformity at the base and maximum regressive surface at the top.
• A transgressive systems tract is bounded by maximum regressive surface at the base and maximum flooding surface at the top. This systems tracts forms when the rate of sedimentation is outpaced by the rate of sea level rise in the sea level curves.
• Highstand occurs during the late stage of base level rise when the rate of sea level rise drops below the sedimentation rate. In this period of sea level highstand is formed. It is bounded by maximum flooding surface at the base and composite surface at the top.
• Regressive systems tract forms in the marine part of the basin during the base level fall. Subaerial unconformities form in the landward side of the basin at the same time.

Parasequences and stacking patterns

A parasequence is a relatively conformable, genetically related succession of beds and bedsets bounded by marine flooding surfaces and their correlative surfaces. The flooding surfaces bounding parasequences are not of the same scale as the regional transgressive surface that is associated with a sequence boundary.

The parasequences are the separated into stacking patterns:

• Aggradational
• Progradational
• Retrogradational

Each stacking pattern will give different information on the behaviour of accommodation space, a major control of which is relative level. So a rapidly progradational pattern will be indicative of falling sea level, rapidly retrogradational is evidence for rapidly transgressing sea level and aggradational will be indicative of gently rising sea level.

Sea level through geologic time

Comparison of two sea level reconstructions during the last 500 Myr. The black bar shows the magnitude of sea level change during the Quaternary glaciations; this is for the past few million years, but the bar is offset further in the past for readability.

Sea level changes over geologic time. The graph on the right illustrates two recent interpretations of sea level changes during the Phanerozoic. The modern age is depicted on the left side, labeled N for Neogene. The blue spikes near date zero represent the sea level changes associated with the most recent glacial period, which reached its maximum extent about 20,000 years Before Present (BP). During this glaciation event, the world's sea level was about 320 feet (98 meters) lower than today, due to the large amount of sea water that had evaporated and been deposited as snow and ice in Northern Hemisphere glaciers. When the world's sea level was at this "low stand", former sea bed sediments were subjected to subaerial weathering (erosion by rain, frost, rivers, etc.) and a new shoreline was established at the new level, sometimes miles basinward of the former shoreline if the sea floor was shallowly inclined.

Today, sea level is at a relative "high stand" within the Quaternary glacial cycles because of rapid end-Pleistocene and early-Holocene deglaciation. The ancient shoreline of the last glacial period is now under approximately 390 feet (120 meters) of water. Although there is debate among earth scientists whether we are currently experiencing a "high stand" it is generally accepted that the eustatic sea level is rising.

In the distant past, sea level has been significantly higher than today. During the Cretaceous (labeled K on the graph), sea level was so high that a seaway extended across the center of North America from Texas to the Arctic Ocean.

These alternating high and low sea level stands repeat at several time scales. The smallest of these cycles is approximately 20,000 years, and corresponds to the rate of precession of the Earth's rotational axis (see Milankovitch cycles) and are commonly referred to as '5th order' cycles. The next larger cycle ('4th order') is about 40,000 years and approximately matches the rate at which the Earth's inclination to the Sun varies (again explained by Milankovitch). The next larger cycle ('3rd order') is about 110,000 years and corresponds to the rate at which the Earth's orbit oscillates from elliptical to circular. Lower order cycles are recognized, which seem to result from plate tectonic events like the opening of new ocean basins by splitting continental masses.

Hundreds of similar glacial cycles have occurred throughout the Earth's history. The earth scientists who study the positions of coastal sediment deposits through time ("sequence stratigraphers") have noted dozens of similar basinward shifts of shorelines associated with a later recovery. The largest of these sedimentary cycles can in some cases be correlated around the world with great confidence.

The three controls on stratigraphic architecture and sedimentary cycle development are:

• Eustatic sea level changes
• Subsidence rate of the basin
• Sediment supply.

Eustatic sea level is the sea level with reference to a fixed point, the centre of the Earth. Relative sea level is measured with reference to the base level, above which erosion can occur and below which deposition can occur. Both eustatic sea level changes and subsidence rates tend to be longer cycles. Sediment supply is largely thought to be controlled by local climatic conditions and can vary rapidly. These variations in local sediment supply affect the local and relative sea level which causes local sedimentary cycles.

Smaller and localised sedimentary cycles are not related to worldwide (eustatic) sea level changes but more to the supply of sediment to the adjacent basins where these sediments are being supplied. For example, when the basinward (oceanward) shift with progradation of shorelines was occurring in the Book Cliffs area of Utah the shorelines were receding or transgressing northwards in Wyoming. These sedimentary cycles are representative of the amount of supply of sediment to the basin. In a transgression, less sediment is being supplied than the rate of increase in the depth of water, and thus the shoreline migrates landward. In a regression, if the water depth is decreasing, the shoreline migrates seaward (basinward) and the previous shoreline is eroded. A regression of the shoreline also occurs if more sediment is being supplied than the shoreline can erode, causing the shoreline to migrate seaward. The latter is called progradation.

Economic significance

These events have economic significance because these changes in sea level cause large lateral shifts in the depositional patterns of seafloor sediments. These lateral shifts in deposition create alternating layers of good reservoir quality rock (porous and permeable sands) and poorer-quality mudstones (capable of providing a reservoir "seal" to prevent the leakage of any accumulated hydrocarbons that may have migrated into the sandstones). Hydrocarbon prospectors look for places in the world where porous and permeable sands are overlain by low permeability rocks, and where conditions are right for hydrocarbons to be generated and migrate into these "traps".

See also

• Cratonic sequence
• Cyclostratigraphy

External links

• A chart of sea level for the past 140,000 years (The different orders of cyclicity can be seen as higher frequency chatter on an overall asymmetric cycle. Today's date is on the right side of this chart.)
• USC's Sequence Stratigraphy Web a fairly extensive online education resource
• An Online Guide to Sequence Stratigraphy by the University of Georgia's Stratigraphy Lab.