Romeo Ro.35

From Infogalactic: the planetary knowledge core
(Redirected from Ro.35 Romeo)
Jump to: navigation, search
Romeo Ro.35
Role Single-seat glider
National origin Italy
Manufacturer Officine Mecchaniche Romeo, Naples
First flight 1933
Number built 1

The Romeo Ro.35, aka IMAM Ro.35 was a single-seat glider built in Italy in 1933.

Design and development

Nicola Romeo was a 20th-century industrialist, remembered mostly through the Alfa-Romeo marque. In the early 1930s his aircraft were manufactured by Meridionali / IMAM - Industrie Meccaniche e Aeronautiche Meridonali, the aeronautical branch of Officine Ferroviarie Meridionali (English: Railway Workshops Meridionali) in Naples;[1] the Ro.35 was constructed by the Officine Mecchaniche Romeo (Mechanical Workshops Romeo).[2]

The Ro.35 was a cantilever high-wing monoplane with the wing mounted on top of the fuselage without dihedral. The one piece wing was built around a single spar and was plywood skinned forward of the spar forming a torsion resistant D-box. The rest was fabric-covered. In plan the wing was straight-tapered and had rounded tips.[2]

The Ro.35 had a simple rectangular cross-section, wooden framed fuselage, skinned with plywood forward and fabric aft. At the nose the sides curved around but the upper and lower surfaces did not meet, giving the Roma a square nosed side view. The open cockpit was set into the wing leading edge, the pilot protected by a small windscreen. Its rear fuselage tapered in plan to the tail, where a short, narrow fin supported a very curved, tall rudder. The tailplane was mounted on the fuselage at the foot of the fin. It too was narrow and with its elevator was straight-tapered and round tipped. The horizontal surfaces were fabric-covered; all the control surfaces were unbalanced. The curved lower rudder edge left clearance for elevator movement.[2]

The glider was unusual in having the option of a fixed, narrow track wheeled undercarriage, with a steel axle passing through the lower fuselage. This could be discarded in favour of a more conventional skid. There was a small tail skid for use with either option.[2]

The Ro.35 first flew in 1933 and the sole example was used by the Naples gliding club, operating from Capodichino. It also visited Poggio Renatico near Bologna.[2]

Specifications

Data from Pedrielli (2011) p.183[2]

General characteristics

  • Crew: One
  • Length: 6.40 m (21 ft 0 in)
  • Wingspan: 14.50 m (47 ft 7 in)
  • Wing area: 15.80 m2 (170.1 sq ft)
  • Aspect ratio: 13.3
  • Empty weight: 100 kg (220 lb)
  • Gross weight: 170 kg (375 lb)

Performance

  • Maximum glide ratio: estimated 11.2:1
  • Wing loading: 10.8 kg/m2 (2.2 lb/sq ft)

References

  1. Lua error in package.lua at line 80: module 'strict' not found.
  2. 2.0 2.1 2.2 2.3 2.4 2.5 Lua error in package.lua at line 80: module 'strict' not found.