Mona Passage

From Infogalactic: the planetary knowledge core
Jump to: navigation, search

Lua error in package.lua at line 80: module 'strict' not found.

File:Mona passage.jpg
Location of the Mona Passage

The Mona Passage is a strait that separates the islands of Hispaniola and Puerto Rico. The Mona Passage connects the Atlantic Ocean to the Caribbean Sea, and is an important shipping route between the Atlantic and the Panama Canal.

The 80 mi (130 km) stretch of sea between the two islands is one of the most difficult passages in the Caribbean. It is fraught with variable tidal currents created by the large islands on either side of it, and by sand banks that extend out for many miles from both coasts.

Islands

There are three islands in the Mona Passage:

Mona Island lies close to the middle of the Mona Passage.

Five kilometers northwest of Mona Island is much smaller Monito Island.

Fifty kilometers northeast of Mona Island and much closer (21 km) to the Puerto Rican mainland is Desecheo Island.

Structure and seismicity

The Passage was also the site of a devastating earthquake and resulting tsunami that hit western Puerto Rico in 1918.[1] It is the site of frequent small earthquakes. The passage is underlain by a seismically active rift zone that overprints an older partly eroded tilted-block structure.[1] Desecheo Island sits on the Desecheo ridge, a narrow east - west ridge that extends west from the northwest corner of Puerto Rico. The ridge forms the southern boundary of the 4000 m deep Mona rift which extends toward the north to the strike slip fault zones which bound Puerto Rico and Hispanola. The east face of the rift has a sharp relief of 3 km and is controlled by the N - S trending Mona Rift Fault. The epicenter of the 1918 earthquake was located along the east or southeast edge of the Mona Rift.[2]

Physical Oceanography of the Mona Passage

The Mona Passage connects the Atlantic Ocean waters and Caribbean Sea waters, above a sill depth of 400 to 500 meters. The sill runs along a northwest to southeast direction between Cabo Engaño (DR) in the west and the Cabo Rojo Shelf (PR) in the east margin of the Mona Passage. The vertical profile of the low-frequency (periods longer than 2 days) mean meridional water transport is characterized by a two-layer structure. The upper layer lies above a depth of 300 meters, with the upper water masses, the Caribbean Surface Water, Subtropical Underwater and Sargasso Sea Water entering the Caribbean Sea from the Atlantic Ocean. Below this layer, the Tropical Central Water exits toward the Atlantic Ocean. The mean value for the meridional (North-South) transport for a sampled year was -1.85 ± 0.25 Sverdrup (Sv) into the Caribbean Sea. [3]

The barotropic tide (surface tide) propagates from northeast to southwest along Mona Passage. The "principal lunar semi-diurnal" constituent, also known as the M2 (or M2) accounts for 52.35% of the total variance observed in the ocean currents and the semidiurnal current ellipses, with a clockwise rotation, are roughly aligned in a north-south direction. [4] Semidiurnal tidal currents impinging on a submarine ridge known as El Pichincho can force the generation of an internal tide with a wave height of 40 meters. [5] Underwater glider observations reveal wave damping as the internal tide propagates south along the Mona Passage towards the open Caribbean Sea. [6] [7] [8] Internal tides at El Pichincho can elevate the turbulent vertical diffusivity values (or Eddy diffusion), and with a reduction of the Richardson number at the base of the pycnocline. The development of Kelvin-Helmholtz instability during the breaking of the internal tide can explain the formation of high diffusivity patches that generate a vertical flux of nitrate (NO3) into the photic zone and can sustain new production locally. [9] Higher values of primary productivity were observed near the wave trough, than those observed during periods of maximum solar irradiance at noon.

Images from the Moderate-Resolution Imaging Spectroradiometer (MODIS) and International Space Station (ISS) photography show the sea-surface manifestation of packets of internal solitons (or nonlinear internal waves) generated at Banco Engaño, located at the northwest margin of the Mona Passage. [10] [11] The packets propagate either into the Caribbean Sea or the Atlantic Ocean depending on the direction of the currents that forced their generation. [12]

Surface tides, internal tides, internal solitons, inertial currents and the low frequency water mass transport between the Atlantic Ocean and the Caribbean Sea make the Mona Passage a very dynamic environment.

Boating

Lua error in package.lua at line 80: module 'strict' not found. Most cruising boaters entering the Caribbean from the north do so via a stop at Samaná in the northeastern part of the Dominican Republic, then continuing across the Mona Passage to Puerto Rico without stopping. Under sail it means an even longer distance because of having to "tack" a zig-zag course into the easterly trade winds.

At the stop of Saona Island on the southeast coast of the Dominican Republic, boaters can sit and wait for a lull in the trade winds when seas are down to start their eastward crossing. This is an advantage which is not possible when departing from Samaná. It is only about 40 miles (64 km) from Saona to the protected anchorage inside the barrier coral reef on the west coast of Mona Island. And from there it is another 40 miles (64 km) to the popular and spacious cruising anchorage at Boquerón in Puerto Rico.

See also

References

  1. 1.0 1.1 http://soundwaves.usgs.gov/2007/05/ Uri ten Brink, New Bathymetric Map of Mona Passage, Northeastern Caribbean, Aids in Earthquake- and Tsunami-Hazard Mitigation, USGS Sound Waves Newsletter, May 2007
  2. Mann, Paul, Active Tectonics and Seismic Hazards of Puerto Rico, the Virgin Islands, and Offshore Areas, Special Paper, Geological Society of America, 2005 p. 118 - 119 ISBN 978-0-8137-2385-3
  3. Lua error in package.lua at line 80: module 'strict' not found.
  4. Lua error in package.lua at line 80: module 'strict' not found.
  5. Lua error in package.lua at line 80: module 'strict' not found.
  6. Lua error in package.lua at line 80: module 'strict' not found.
  7. Lua error in package.lua at line 80: module 'strict' not found.
  8. Lua error in package.lua at line 80: module 'strict' not found.
  9. Lua error in package.lua at line 80: module 'strict' not found.
  10. Lua error in package.lua at line 80: module 'strict' not found.
  11. Lua error in package.lua at line 80: module 'strict' not found.
  12. Lua error in package.lua at line 80: module 'strict' not found.


External links