Electric Park Brake

From Infogalactic: the planetary knowledge core
(Redirected from Electric parking brake)
Jump to: navigation, search

Electric Park Brakes are used on passenger vehicles to hold the vehicle stationary on grades and flat roads. This was accomplished traditionally using a manual Parking brake. With Electric Park Brakes, the driver activates the holding mechanism with a button and the brake pads are then electrically applied onto the rear brakes.[1] This is accomplished by an Electronic Control Unit and an actuator mechanism. There are two mechanisms that are currently in production: 1. Cable Puller systems and 2. Caliper integrated systems.[2]

First installed in the 2002 BMW 7 Series (E65), electric park brakes have since appeared in a number of vehicles.

Functionality

Apart from performing the basic vehicle holding function required of park brakes, the EPB systems provide other functions like automatic release of the Park brakes when the driver presses the accelerator, and re-clamping using additional force on detection of vehicle motion.[2] Further, the hill-hold function, which applies brakes to prevent roll-back when pulling away on a gradient, can also be implemented using the EPB.[3]

Implementation

The implementation of the control logic for the actuators is carried out by either using a stand alone ECU[4] or by integrating it in the ECU for Electronic Stability Control[5]

Standards

The design of the Electric Park Brakes should be compliant with

References